| |
|
 |
TE Connectivity Ltd
|
| Part No. |
24088-7 314077-1 314077-2
|
| OCR Text |
... hold dies in place but do not tighten fully. 2. close handles until the dies bottom. then tighten bo th holding screws. the tool can now be used to crimp the contacts to wires. note i check die alignment and tighten die ? holding screw... |
| Description |
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.
|
| File Size |
149.70K /
4 Page |
 View
it Online |
Download Datasheet
|
| |
|
|
TE Connectivity Ltd
|
| Part No. |
91911-3
|
| OCR Text |
... retaining screw. do not fully tighten. 3. install the indenter die into the stationary jaw of the tool frame. slowly close the tool handles, allowing the dies to align themselves. after the anvil die has mated with the indenter die, pl... |
| Description |
crimping chamber crimps the center contact onto the center conductor of the coaxial cable.
|
| File Size |
57.82K /
3 Page |
View
it Online |
Download Datasheet |
| |
|
|
Mallory performance clu...
|
| Part No. |
PN8560
|
| OCR Text |
... locknut. use care not to over-tighten. locking out the centrifugal advance on a ford 1. remove the cap and rotor. 2. remove the advance springs, weights and the advance stop bushing from the advance assembly. 3. remove the roll... |
| Description |
MSD Pro-Billet Marine Distributor
|
| File Size |
326.02K /
8 Page |
View
it Online |
Download Datasheet |
| |
|
|
Mallory performance clu...
|
| Part No. |
PN8523
|
| OCR Text |
...washer through the lockout and tighten. it is important to make sure the pickup plate is parallel with the housing of the distributor (figure 10). if it is cocked or slanted, the paddles of the reluctor may contact the pickup. check th... |
| Description |
MSD Pro-Billet Ready-to-Run AMC V8 Distributor
|
| File Size |
638.57K /
8 Page |
View
it Online |
Download Datasheet |
| |
|
|
Mallory performance clu...
|
| Part No. |
PN85501
|
| OCR Text |
...asher and locknut. do not over tighten. locking out the centrifugal advance 1. remove the advance components including the springs, weights and the advance stop bushing from the advance assembly. 2. remove the roll-pin from the drive... |
| Description |
MSD Pro-Billet Chevrolet V8 Distributor
|
| File Size |
284.66K /
8 Page |
View
it Online |
Download Datasheet |
| |
|
|
RADIALL S A
|
| Part No. |
R222.221.702
|
| OCR Text |
...de positoner into the assembly. tighten. solder the body onto the cable. after cooling remove cable assembly from the jig. we recommend a thermal preconditionning cable stripping cables a insulator tighten solder connector positioner solder... |
| Description |
PANEL MOUNT, CABLE TERMINATED, MALE, RF CONNECTOR, SOLDER, JACK
|
| File Size |
34.38K /
3 Page |
View
it Online |
Download Datasheet |
|
Price and Availability
|
